of
ANSI
Standard A119.2, The National Electrical Code and
Canadian Standards Association.
Your new Jayco tent camper is equipped with
a
15-amp power cord
to connect from the campground outlet to your camper, the power
cord is pre-wired into the distribution panel with a 15-amp
overcurrent protection breaker and then supplies 120-volt
AC
to the
12-volt
DC
power convertor.
To
prevent accidental electrical shock, insure that
the
ground pin
on the attachment plug
cap
is
intact to the earth ground through
the
R.V.
park receptacle. When plugged into a receptacle with no
provision for the third pin, use an adapter with a pigtail that can
be
connected
to
the receptacle
box,
with the grounding circuit
completed through the ground pin or
R.V.
park receptacle box, any
accidental short of a live circuit conductor will trip the circuit.
breaker indicating a shorted circuit.
You
should be certain that
the
polarity
of
the
external power
is
not reversed, in order
to
avoid
harm to appliances and personal electrical shock. Polarity
indicators may
be
purchased in many electrical and hardware
stores.
Plug
ANSI
C73
13
-
120V.
30
Amps,
2
Pole.
3
Wire
Grouiidlng
Type
CHANGES,
MODIFICATIONS,
AND
ADDITIONS
Any
changes or additions made after delivery may
develop
a
hazardous condition.
Be
sure to consult your local authorized
dealer. Only qualified electrical technicians should attempt to
make changes, or additions to our electrical system, using only
approved materials
and
components and employing approved
methods
of
installations.
Extension cords should always be a heavy gauge of wire equal to
the
power cord. Usage
of
too small a cord
will
result
in
overheating and possibly burning of the cord.
DO
NOT
leave
an
unused
portion
of an extension cord
in
a
coil
as
it
will
overheat and
short out wires.
To Next Page
Loading...
Need help?
General
