IV.
SET-UP
PARKING
AND
LEVELING
INSTRUCTIONS
BOTH
UNITS
1.
Park your FeatherLite trailer as near level as possible. If one side
is
higher than the other side, install wood blocks under wheels to
level wheels.
Do this before unhooking trailer
from
tow vehicle.
2.
Block wltcels so trailer won't roll.
3.
Unhook
12V
electrical connection, safety chains,
and
then the
coupler from hitch.
4.
Now leveI the trailer from front to rear
by
usage of stabilizer
jacks
and tongue jack.
CAUTION: Failure
to
block
and
stabilize
your
FeatherLite
trailer
may
cause
it
to
relocate itself,
due
to
its
light
1
weight.
SET-UP
INSTRUCTIONS
FEATHERLITE
I
ONLY
1.
Remove
the
vinyl cover
by
unhooking shock cord
from
the nylon
wheels
on
the back and both sides. (Figure
1)
2.
Roll the vinyl cover to the front
of
camper and lay it on the tongue
of trailer. (To remove the cover, pull to one
(1)
side
of the camper
and out of the rail.)
Fig.
1
Fig.
2
3.
Pull the rear bed out about
3/4
of its total distance.
4.
Proceed to pull the front bed out completely following these
instructions: Standing in front of camper, grasp tent and bed
extrusion with both hands, press down on bed and pull out
at
the
same time.
If
you don't press down, the bed may
be
difficult to
pull out.
Pull canvas apron over edge of bed on both sides.
5.
Insert the two bed support poles as shown in Figure
2.
To Next Page
Loading...
Need help?
General
