CONVERTOR
Your interior lights(s) and the
660
series heater (optional) will
operate from the 12-volt power source.
if
110-volt
AC
is available,
the convertor
will
transform this current to 12-volt. This needs to
be switched manually. The
TRANS
position is used when the
110-volt current needs lo be transformed to
112
volt. The
BATTERY
position is used when all current
is
to be received from
battery either
in
tow vehicle or optional auxiliary
if
used. The
OFF
position is used for traveling or storage.
These convertors
DO
NOT
have a
built-in
battery charger.
BATTERY
(OPTIONAL)
A11
Jayco units are pre-wired so that all interior 12-volt appliances
can
be
operated when the tow vehicle and coach are connected via
the wiring harness.
This
is possible only if the dealer connects the
black wire
of
the wire harness to
a
"hot" supply. An auxiliary
battery
may
be
installed to avoid discharging the vehicle battery.
Caution should
be
used when drawing current
from
your tow
vehicle to avoid draining the battery to a point that the tow vehicle
will
not start.
FUSES
For the Jay FIight series an inline fuse for the interior circuit
is
installed, located
in
the
left
front corner
of
the camper under the
dinette seat. The replacement
fuse
size
is
8A.
Other Jayco
model
tent
campers
have the interior circuit directed
through the convertor.
WARNING:
Do not replace circuit breakers or
fuses
with
those
of
a
higher
current rating
than
those supplied
with
the
new
camper.
Over-fusing
can
cause
a
fire
hazaxd
by
overheating
above
the
"
temperature
rating
of the electrical
wiring.
To Next Page
Loading...
Need help?
General
