JAYCO TOWABLE SECTION 4 – VEHICLE OPERATION
4-15
BED BRACE SET UP: HITCH MOUNT (If So Equipped)
Step 5 – hitch mount
Do not exceed the limits of the cables. Cables are located on
opposite corners of the unit.
Step 6 – hitch mount
Pull out the front bed. Make sure the bed is fully
extended.
Step 7a – hitch mount
Install the bed braces. Lifting up slightly on the bed
will help with the brace installation.
The brace should be
positioned so the bolt is
facing away from the RV.
Insert the free end of the
brace securely into the slot
on the RV hitch (front) and
the RV bumper (rear).
Repeat Step 6 and 7 on the
rear bed.
To Next Page