SECTION 4 – VEHICLE OPERATION JAYCO TOWABLE TABLE OF CONTENTS
4-30
The alternate canopy set-up is complete.
Caring For Your Canopy:
Rain can damage both the canopy fabric and the poles if it is allowed to “pocket” in the
fabric. It is very important to have the correct slope in the canopy. If rain is anticipated or
forecast, lower one side to allow
adequate run off.
SCREEN ROOM (IF SO EQUIPPED)
NOTE: The canopy and hardware must be installed and set up before attempting to
attach the screen room (see Canopy set-up and Care). It will be easier to install the screen
room prior to staking down the canopy legs and raising the roof.
Installing the Screen Room Skirt:
1. Unfold the screen room skirt and lay out under the canopy area. A grassy area or
clean floor is suggested.
2. Starting at one end, snap the screen room skirt to the side of the unit, until all snaps
have been installed. The Velcro should line up with the screen room sides.
3. Install wheel well cover to the snaps above the wheel well. Once installed place
adhesive Velcro provided, adhesive side to the skirt. Be sure to align adhesive Velcro
with the Velcro sewn on the corners of wheel well cover.
CAUTION
Wind and rain can cause damage to the canopy, resulting in injury or damage to the
vehicle. If wind or heavy rain is expected fold up and stow the awning. If leaving
the vehicle for an extended period of time, stow the canopy to avoid potential
damage from weather changes.
To Next Page
Loading...
