120
7. Put the sanitizer solution in the fresh water tank. Insert one end of a hose (or funnel) in
the gravity ll inlet; insert the other end into a container holding the chlorine solution.
Pour the chlorine solution into the
gravity ll.
8. Remove the hose (or funnel) and container used to pour the chlorine solution, and con-
tinue lling the fresh water tank with clean (potable) water until tank is full. Pour fresh
water into the gravity ll inlet until tank is completely full. After the recommended
amount of sanitizing solution is in the tank, the water tank is full, and water lter has
been removed and bypassed, turn the pump ON which sends sanitizer into the water
lines.w
9. Open all hot water faucets one by one until water begins to ow continuously and a
chlorine smell is noticeable. Include outside shower faucets (if so equipped).
10. Close the hot water faucets and repeat opening all cold water faucets one by one until
you smell chlorine. Include outside shower faucets (if swo equipped) and toilet.
11. Turn OFF the water pump.
12. Let the solution remain in the tank & lines for at least four hours when disinfecting with
50-PPM residual chlorine. If a shorter time is desired, then a 100-PPM chlorine con-
centration should be permitted to sit in the system for at least one hour.
13. After the required period, drain the chlorine solution from the fresh water system.
Since the water heater was bypassed there should be no sanitizer in the (storage) tank
water heater.
14. Fill the fresh water tank full of clean (potable) water. Fill fresh water tank from an
external container. Pour fresh water into the gravity ll inlet using a hose (or funnel).
15. Power to water heater should be OFF (both switches: electric & LP gas). When the
fresh water tank is full, turn the pump ON to send water through the lines. Water heater
bypass valves should still be set to .
16. Run water through all faucets (hot & cold, including outside shower) until chlorine
smell is gone. Turn faucets and outside shower o, turn pump OFF.
17. Then, drain the fresh water system again (see Draining the Fresh Water System).
18. : Allows water into the water heater. Replace
the water heater drain plug.
19. Rell the fresh water tank with fresh water again and when water heater is full of water,
turn the water heater power ON. Pour fresh water into the gravity ll using a hose or
funnel.
To thoroughly sanitize the fresh water tank, the unit should be
driven around for a period of time allowing the solution to splash the sides
and top of the tank
To Next Page
Loading...
