To Next PageTo Next Page
Need help?Do you have a question about the JB Systems AX Series and is the answer not in the manual?
General| Number of channels | 2 |
|---|---|
| Input impedance | 10k Ohms |
| Signal-to-noise ratio | >100dB |
| THD | <0.02% |
| Frequency response | 20 Hz - 20 kHz |
| Protection | Thermal, short circuit, DC protection |
| Cooling | Variable speed fan |
| Connectors (input) | XLR and 6.3mm jack |
| Connectors (output) | Speakon |
Lists the main features of the amplifier, including protection and connectivity options.
Details the items that should be present in the carton before operating the amplifier.
Provides critical guidelines for safe and optimal operation, including ventilation and environment.
Explains how to clean the unit using water-dipped cloths and vacuum cleaners for ventilation.
Offers advice on connecting signal inputs and speaker outputs using XLR and Speakon connectors.
Details the power LED, main switch, and gain controls for setting input sensitivity.
Explains the function of CLIP LEDs and PROTECT LEDs for amplifier status.
Describes BRIDGE and PARALLEL mode LEDs and the importance of ventilation holes.
Details Speakon and binding post outputs for connecting speaker cabinets.
Explains the ground lift switch for hum noise and the mode switch for stereo/bridge/parallel.
Illustrates connections for STEREO, BRIDGE, and PARALLEL modes with wiring diagrams.
