ENGLISH OPERATION MANUAL
JB SYSTEMS® 7/48 iCOLOR4
• DMX-CONFIGURATION OF iCOLOR4:
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during
servicing.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened
and may not be corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally
free from any deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be
replaced.
• The mains cables must be in impeccable condition and should be replaced immediately
when even a small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation
openings should be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• The cleaning of internal and external optical lenses and/or mirrors must be carried out
periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surroundings can cause
greater accumulation of dirt on the unit’s optics.
• Clean with a soft cloth using normal glass cleaning products.
• Always dry the parts carefully.
• Clean the external optics at least once every 30 days.
• Clean the internal optics at least every 90 days.
Attention:
We strongly recommend internal cleaning to be carried out by qualified
personnel!
ENGLISH OPERATION MANUAL
JB SYSTEMS® 8/48 iCOLOR4
SPECIFICATIONS
Mains Input: AC 230V, 50Hz
Fuse: 250V 15A slow blow (20mm glass)
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
Lamp: 4x R7S 500W/230V (J Type)
Size: 45 x 27 x 17.5cm
Weight: 7kg
Every information is subject to change without prior notice
To Next Page
Loading...
Need help?
General
