To Next PageTo Next Page
Need help?Do you have a question about the JBL A6000GTi and is the answer not in the manual?
General| Brand | JBL |
|---|---|
| Model | A6000GTi |
| Category | Car Amplifier |
| Language | English |
Provides essential safety precautions and general advice for installing the amplifier.
Guides users on selecting the most suitable place to mount the amplifier within a vehicle.
Details the physical process of securing the amplifier to a chosen mounting surface.
Describes how to wire speakers in series for calculating total impedance.
Explains how to wire speakers in parallel for calculating equivalent impedance.
Details series, parallel, and series-parallel wiring for dual voice-coil speakers.
Discusses RMS power handling ratings and their relation to music types.
Emphasizes the necessity of sufficient input power for full amplifier output.
Explains the roles of the battery and alternator in the vehicle's electrical system.
Discusses how music types affect the amplifier's current draw.
Details the correct wiring for power supply and ground connections to the amplifier.
Explains how to connect audio sources using RCA cables to the amplifier.
Describes connecting remote controls and accessory gauges via RJ45 connector.
Provides instructions on how to safely connect speaker systems to the amplifier.
Specific guidance for connecting speakers to the A6000GTi model.
Details connecting the A6000GTi in bridged mode for 2 ohms or greater impedance.
Details connecting the A6000GTi in parallel mode for 2 ohms or less impedance.
Details connecting the A6000GTi for 2-channel stereo operation with 2-4 ohms impedance.
Specific guidance for connecting speakers to the A3000GTi model.
Explains how to set the output load switch for optimal amplifier performance.
Details connecting the A3000GTi in bridged mode for 2 ohms or greater impedance.
Details connecting the A3000GTi in parallel mode for 2 ohms or less impedance.
Details connecting the A3000GTi for stereo operation with 2-4 ohms impedance.
Instructions for adjusting the crossover frequency and slope settings.
Details on setting the input gain control for optimal signal strength.
Guidance on adjusting the phase control for proper speaker timing.
Explanation of the Dynamic Bass Optimizer (DBO) and its settings.
Step-by-step instructions for disassembling the amplifier to replace parts.
Details the actual replacement steps for fuses and neon tubes.
