Need help?Do you have a question about the JBL CS300.1 and is the answer not in the manual?
Power| power at 4 ohms | 200W RMS x 1 channel |
|---|---|
| power at 2 ohms | 300W RMS x 1 channel |
| dynamic power at 2 ohms | 460W |
Audio Performance| signal-to-noise ratio | 100dBA |
|---|---|
| frequency response | 10Hz – 300Hz |
| effective damping factor | 6.395 at 4 ohms |
Input and Output| maximum input signal | 6V |
|---|---|
| maximum sensitivity | 100mV |
| output regulation | –0.07dB at 4 ohms |
Weight and Dimensions| dimensions (L x W x H) | 12-11/16" x 10-1/4" x 2-3/16" |
|---|---|
| fuses | 20A x 2 |
Power| power at 4 ohms | 60W RMS x 4 channels |
|---|---|
| power at 2 ohms | 80W RMS x 4 channels |
| dynamic power at 2 ohms | 145W |
Audio Performance| signal-to-noise ratio | 86dBA |
|---|---|
| frequency response | 10Hz – 27kHz |
| effective damping factor | 6.395 at 4 ohms |
Input and Output| maximum input signal | 6V |
|---|---|
| maximum sensitivity | 100mV |
| output regulation | –0.03dB at 4 ohms |
Weight and Dimensions| dimensions (L x W x H) | 13-1/4" x 10-1/4" x 2-3/16" |
|---|---|
| fuses | 25A x 2 |
Power| power at 4 ohms | 60W RMS x 2 channels |
|---|---|
| power at 2 ohms | 80W RMS x 2 channels |
| dynamic power at 2 ohms | 160W |
Audio Performance| signal-to-noise ratio | 86dBA |
|---|---|
| frequency response | 10Hz – 27kHz |
| effective damping factor | 6.395 at 4 ohms |
Input and Output| maximum input signal | 6V |
|---|---|
| maximum sensitivity | 100mV |
| output regulation | –0.03dB at 4 ohms |
Weight and Dimensions| dimensions (L x W x H) | 8-7/8" x 10-1/4" x 2-1/4" |
|---|---|
| fuses | 25A x 1 |
Expresses gratitude for purchase, provides warranty advice, and emphasizes professional installation.
Provides crucial safety advice, including eyewear use, battery disconnection, and avoiding vehicle lines.
Guidance on selecting a suitable, safe, and well-ventilated mounting spot for the amplifier.
Details on connecting ground, power, remote turn-on, and speaker wires for optimal performance.
Provides a chart for selecting appropriate wire gauges based on amplifier model and current draw.
Illustrates how to connect one or two subwoofers to the single-channel CS300.1 amplifier.
Shows 4-channel, 3-channel, and bridged 2-channel modes for driving speakers and subwoofers.
Demonstrates 2-channel stereo operation for speakers and bridged mode for a subwoofer.
Guidance on adjusting crossover settings (FLAT, HP, LP) for different speaker configurations.
Instructions for adjusting input level controls to prevent distortion and optimize sound.
Identifies symptoms like no audio or distorted audio and provides likely causes and solutions.
Lists detailed performance metrics including RMS power, frequency response, and dimensions.
Details performance metrics for the CS60.4, including power output and impedance ratings.
Outlines the technical specifications for the CS60.2 amplifier, covering power and dimensions.
States compliance with technical standards and mentions CEA-2006 power standard.
To Next Page
