Using Loop-Through Terminals (Pins 1
&
4)
--By
connecting the wire pair
of
the
subsequent speaker to pins 1
&
4, then all subsequent speakers will
be
disconnected
when this speaker's connector is disconnected during for troubleshooting,. This can
be useful as a way to isolate problems to a section
of
the distributed line while leaving
the wires attached to the connector.
Figure 9:
Terminals
f~~"l-rhrough
~~W#i~·~
From Amplifier
or
~
-
- -
To
Subsequent
Previous
Speaker
_
+
Soeakers
Figure
10:
Loop-Through
System Hookup
Diagram
+ -
Power Amplifier
Speaker 1 Speaker 2 Speaker 3
+
Choose whichever hookup pattern accommodates your installation best.
To
Subsequent
Speakers
Step 4 - Plug connector into connector socket in the speaker's terminal cup.
Figure
11
:
Plugging Connector Into
Connector Socket
9
To Next Page
Loading...
