Need help?Do you have a question about the JBL GTO3501 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Input Sensitivity | 200 mV - 4 V |
| Amplifier Class | D |
| Subsonic Filter | 25 Hz |
| Fuse Rating | 30 A |
| Crossover | Variable |
| RMS Power @ 4 Ohms | 350 Watts |
| RMS Power @ 2 Ohms | 500W |
| Low-Pass Filter | Variable 32 Hz - 320 Hz |
| Bass Boost | 0 - 12 dB |
Connect the subwoofer to these terminals observing proper polarity. Minimum total impedance is 2 ohms.
Connects +12V to battery, GND to chassis, and REM to source unit's remote out or switched 12V+.
Matches amplifier input level to source unit output level. Includes adjustment procedure.
12dB/octave low-pass filter, variable from 32Hz to 320Hz. Includes adjustment procedure.
Indicates fault conditions like voltage issues, short circuits, overheating, or output failure.
Procedure to set the input level control for optimal bass output proportionality.
Procedure for setting the crossover frequency for subwoofers.
Details power output, frequency response, maximum input signal, sensitivity, THD+N, and signal-to-noise ratio.
Variable subsonic high-pass filter with variable boost for tuned enclosures or sealed boxes.
Connector for the Remote Level Control, allowing bass adjustment from the listening position.
To Next Page
