JBL GX-A3001 - Sound Quality Troubleshooting

www.jbl.com
English
25
PROBLEM CAUSES AND SOLUTIONS
Sound only comes from some of the speakers
connected to the amplifier
•Checkthatthevehicleaudiosystem’ssourceunit’sbalanceandfadercontrolsaresettotheir
center (midpoint) positions.
•(GX-A604):Checkthatthesettingoftheamplifier’sModeSwitchmatchestheinputandspeaker
connections made to the amplifier
Sound is too quiet, even with the vehicle audio
system’s source unit volume all the way up
•Checkthattheamplifier’sLevelcontrolsarenotturnedtoolow.SeeSet The Input Level, on
page 22, for information about setting the Level controls.
Sound in the front/rear speakers is distorted •Makesuretheamplifier’sCrossoverFilterswitchforthedistortedchannelsissettoHP.
•SettheCrossovercontrolforthedistortedchannelstoahighersetting.
•Checkthatthedistortionisnotoriginatingfromthevehicleaudiosystem’ssourceunit.
Sound in the subwoofer is distorted •(GX-A604,GX-A602):SettheBassBoostswitchto"OFF".
•(GX-A3001):Whilelisteningtobass-heavymusic,turntheBassBoostcontrolallthewaydown,
and then gradually increase it until the distortion begins to return. Reduce the Bass Boost
control setting slightly to eliminate the distortion and leave it set there.
•Checkthatthedistortionisnotoriginatingfromthevehicleaudiosystem’ssourceunit.