If there is no sound from
any of the speakers:
• Check that receiver/
amplifier is on and that a
source is playing.
• Review proper operation
of your receiver/amplifier.
If there is no sound coming
from one speaker:
• Check the “Balance”
control on your receiver/
amplifier.
• Check all wires and
connections between
receiver/amplifier
and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
If the system plays at low
volumes but shuts off as
volume is increased:
• Check all wires and
connections between
receiver/amplifier
and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
• If more than one pair of
main speakers is being
used, check the minimum
impedance requirements of
your receiver/amplifier.
If there is no (or low) bass
output:
• Make sure the polarities
(+ and –) of the left and right
“Speaker Inputs” are
connected properly.
If there is no sound from
the center speaker:
• Make sure that your
receiver’s “Center-Channel”
mode is in the ”Normal“ or
”Wide“ position. If it is in
the ”Phantom“ position, the
center speaker will not play.
• Check all connections
between processor/
amplifier and the
center speaker.
To Next Page
Loading...
Need help?
General
