JBL PRX812W - Factory Reset Procedures; Factory Hard Reset Procedure; Factory Soft Reset Procedure

19
The following Factory Resets will reset settings back to their factory default state. This can be useful when you
ZLVKWRUHFRQ¿JXUHDVSHDNHUIURPVFUDWFK
WARNING: Performing the following reset procedures will result in the loss of settings and cannot be undone!
Factory Hard Reset
The Factory Hard Reset resets all DSP and network settings back to their factory default state.
To perform the Factory Hard Reset:
1. Turn the speaker power off.
2. 3UHVVDQGKROGWKH32/$5,7<RU6<67(0(41250%2267RU0$,1021,725EXWWRQWKHQWXUQ
the speaker power back on. Keep the button held for 5 seconds or until the LED above the POLARITY or
6<67(0(41250%2267RU0$,1021,725EXWWRQÀDVKHVEULHÀ\
3. All DSP and network settings have now been reset back to the factory default.
Factory Soft Reset
The Factory Soft Reset resets DSP settings back to their factory default state — network settings will not be
reset.
To perform the Factory Soft Reset:
1. While the speaker is on, press and hold the POLARITY or SYSTEM EQ (NORM/BOOST or MAIN/
021,725EXWWRQIRUVHFRQGV
2. Any DSP settings that have been altered will now be returned to the factory default.
FACTORY RESETS