jcb 0960 - Before Starting

Put the car upside down on a soft cloth or smooth plane firstly (Can't
be directly placed on the surface of the cement, etc., which will
scratch the surface of the plastic), then take off the cardboard, foam,
nylon cable ties.
Preparation work:
Step 1-1: Install the front wheels
A
Use A (M8 Spanner) to remove [1] and [2] from the front axle.
[1]
[2]
[1]
[2]
Step 1-2: Install the front wheels
A
Slide Part C1 (Front wheel) , [2] , [1]onto the front axle, snap B (wheel
cover) onto each wheel.
[1]
[2]
[1]
[2]B B
C1 C1
1
D
[3] [4][4] [3]
2
D
Step 2-1: Install the rear wheel
1. Remove [4] and [3] on D (rear axle).
2. Pass D(rear axle) through left motor, body, right motor.
A*2
*Keep this one, not need to remove.
Cut all the Zip-Tie holding down Frame.
BEFORE STARTING: