jcb 260T Operator's Manual

About the Product
Product and Component Identification
10 9831/0200-4 10
Product and Component Identification
Machine
Machine Identification Plate
Your machine has an identification plate. The PIN (Product Identification Number), weight, engine power, year
of manufacture and serial number of the machine are shown on the identification plate.
The serial number is also permanently stamped into the chassis.
Figure 6.
A
B
A Identification plate (location) B Serial number (stamped)
Typical Product Identification Number
The machine model and build specification are indicated by the PIN. The PIN has 17 digits and must be read
from left to right.
Table 1. Typical PIN
GE0 260 WV H 02196001
Table 2. Explanation of the PIN
Digit Description
1 to 3 World manufacturer identification. For example, JCB = UK Build. GE0 = USA Build
4 to 6 Machine type. For example, 260 = 260
7 to 8 Machine model. For example, W = Wheeled T = Tracked V = Vertical Lift R = Radial Lift
9 Generated Check Letter. The random check letter is used to verify the authenticity of a
machine's PIN.
10 to 17 Machine serial number 02196001.
Engine
The engine data labels are attached to the cylinder block as shown. Refer to Figure 7.

jcb 260T Specifications

General

Operating Weight	9, 774 lbs
Engine Power	55 kW
Rated Operating Capacity	2, 600 lbs
Tipping Load	7, 429 lbs
Lift Path	Vertical
Net Engine Power	55 kW
Width	69.1 in
Max. Travel Speed	12.6 km/h
High Flow	90 L/min
Length with Bucket	3, 500 mm
Bucket Capacity	0.48 m³
Max Travel Speed	12.6 km/h
Breakout Force	38.6 kN
Length	3, 500 mm
Height	2, 200 mm
Pump Flow	60 L/min