jcb 419S - Operator Protective Structure

About the Product
Product and Component Identification
11 9831/2000-4 11
Figure 6.
A
A Engine data label - rocker cover
Figure 7.
M
ANU
F
A
C
TURED
IMPO
R
T
ANT ENGINE INFOR
M
A
TION:
B
Y
CUMMINS INC.
Injury may result andwarranty
is voided if fuelrat
e
, rpm or altitudes
exceed published maxim umvaluesfor this
model and application
WARNI NG:
Engine No.
Ref. No.
Fuel Rateat A
d
v.HP
MODEL
at rpm F
am ily
FEL
Mm³
Store
EPA
CPL
CARB
Idle Speed (rpm) Advertised HP
Timing .T.D.C. ELECTRONI C Catalyst No.
NO
x . NMHC
Fi
r
ing Order
Valve lashcold Int. Exh.
This engine isexem pt from the prohibitions of section 203 (a) (1) (3)
& (4) of the cleanAir
A
ct as amended.
E. C. S. PM
C. I .D.
of
Date
Assembledin the USA
3957607
Mfg:
Engine data label
Operator Protective Structure
ROPS and FOPS Data Plate
WARNING You could be killed or seriously injured if you operate a machine with a damaged or missing
ROPS/FOPS/FOGS. If the ROPS/FOPS/FOGS has been in an accident, do not use the machine until the
structure has been renewed. Modifications and repairs that are not approved by the manufacturer may be
dangerous and will invalidate the ROPS/FOPS/FOGS certification.
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
WARNING Machines with a ROPS, FOPS,FOGS or TOPS are equipped with a seat belt. The ROPS,
FOPS,FOGS or TOPS is designed to give you protection in an accident. If you do not wear the seat belt you
could be thrown off the machine and crushed. You must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
A machine built to the ROPS (Roll-Over Protective Structure)/FOPS (Falling Object Protective Structure)
standard has a data plate attached to the inside of the cab.