Section 1 - General Information
Introduction
Identifying your Machine
1 - 3 1 - 3
9803/4180-08
Identifying your Machine
Machine Identification Plate
Your machine has an identification plate mounted as
shown. The serial numbers of the machine and its major
units are stamped on the plate.
Note: The machine model and build specification is
indicated by the PIN. Refer to Typical Product
Identification Number (PIN).
The serial number of each major unit is also stamped on
the unit itself. If a major unit is replaced by a new one, the
serial number on the identification plate will be wrong.
Either stamp the new number of the unit on the
identification plate, or simply stamp out the old number.
This will prevent the wrong unit number being quoted when
replacement parts are ordered.
The machine and engine serial numbers can help identify
exactly the type of equipment you have.
T033550-2
Fig 2.
Typical Vehicle Identification Number
1 World Manufacturer Identification, SLP = JCB
2 Machine Model, 456ZX
3 Year of Manufacture (P = 1993, R = 1994, S = 1995,
T = 1996, V = 1997, W = 1998, X = 1999, Y = 2000, 1
= 2001, 2 = 2002, 3 = 2003, 4 = 2004)
4 Manufacturers Location (E = England)
5 Machine Serial Number (0539001)
The serial number of each major unit is also stamped on
the unit itself. If a major unit is replaced by a new one, the
serial number on the identification plate will be wrong.
Either stamp the new number of the unit on the
identification plate, or simply stamp out the old number.
This will prevent the wrong unit number being quoted when
replacement parts are ordered.
The machine and engine serial numbers can help identify
exactly the type of equipment you have.
1234 5
SLP 456 V E 539000
Find manuals at https://best-manuals.com
To Next Page
Loading...
