Routine Maintenance
CAPACITIES AND SPECIFICATIONS
Note: New engines DO NOT require a running-in period. The engine should be used in a normal work cycle immediately; glazing
of the piston cylinder bores, resulting in excessive oil consumption, could occur if the engine is gently run-in. Under no
circumstances should the engine be allowed to idle for extended periods (e.g. warming-up without load).
Item Fluid/Lubricant International Specification Capacity
ENGINE See separate chart - 6.8 litres
(1.49 UK gal)
(1.79 US gal)
TRACK GEARBOXES JCB Gear Oil HD90 API-GL-5, MIL-L-2105C 2 x 1.7 litres
(0.37 UK gal)
(0.44 US gal)
TRACK ROLLERS AND
IDLER WHEEL Engine Oil (see separate chart) - -
HYDRAULIC SYSTEM JCB Special Hydraulic Vickers 35VQ25/V104C: 92 litres
Fluid HP46 Sundstrand, Denison and (20.26 UK gal)
FZG Approval Tests (24.33 US gal)
SLEW RING
- BEARINGS JCB HP Grease Lithium Complex (NLGI 2) inc. -
- GEAR TEETH JCB HP Grease extreme measure additives 3.2 kg (7.14 lb)
ALL OTHER GREASE Lithium Complex (NLGI 2) inc.
POINTS JCB HP Grease extreme measure additives
COOLING SYSTEM See Coolant Mixtures ASTM D3306-74 10.1 litres
(2.22 UK gal)
(2.66 US gal)
FUEL TANK See Fuel System, ASTM D975-66T 140 litres
Types of Fuel Nos 1D, 2D (30.8 UK gal)
(37.0 US gal)
Engine Lubrication Chart
Use according to ambient temperature (°C)
JCB SUPER 15W/40 MULTIGRADE ENGINE OIL
API CF4/SG MIL L-2104F
JCB SUPER 10W/30 MULTIGRADE ENGINE OIL
API CF4/SG MIL L-2104F
To Next Page
Loading...
Need help?
General
