6
TH32006
Instruction & User Manual
3. Verify lift point, insert handle into handle
sleeve and pump to contact lift point.
To lift, pump handle until load reaches
desired height.
4. Transfer the load immediately to appropri-
ately rated jack stands.
Lowering
1. Raise load high enough to clear the jack
stands, then carefully remove jack stands
(always used in pairs).
2. Slowly turn the handle anti-clockwise, but
no more than a 1/2 full turn.
3. After removing jack from under the load,
push saddle down to reduce ram exposure
to rust and contamination.
MAINTENANCE
Use only a good grade hydraulic oil (e.g. Mobil
TDE 13M or equivalent). The oil level must
never overflow its housing.
With the cup all the way down and the piston
pump all the way in, level the jack in the upright
position. Remove the oil filler cap. Fill until the
oil level reaches the hole in the filler and refit
the filler cap.
STORAGE
When not in use, store the jack with saddle
fully lowered.
DECOMMISSIONING
When disposing of this product, in accordance
with current regulations, please dispose of it
at a facility provided for that purpose so that
it may be recovered, reused, recycled or de-
stroyed in a safe, environmentally-friendly way.
BEFORE USE
1. Verify that the product and the application
are compatible
2. Before using this product, read the
owners manual completely and familiarize
yourself thoroughly with the product, its
components and recognize the hazards
associated with its use.
3. Check to ensure that the jack rolls freely
and that the pump operates smoothly
before putting into service.
REMAINING RISK
OPERATION
Lifting
1. Place vehicle in park, with emergency
brake on and wheels securely chocked to
prevent inadvertent vehicle movement.
2. Locate and close release valve by turning
handle clockwise until firm resistance is felt
to further thread engagement. Center jack
saddle under lift point.
BRAKE
Park your vehicle and apply
the handbrake to avoid any
unexpected movement.
Use only on hard, level surfaces
capable of supporting the load
marked on the jack.
Put the vehicle in gear before
lifting, to avoid any unexpected
movement.
To Next Page
Loading...