1. Using the Phone
1.1 Battery
The battery is attached with the mobile phone. The battery is not charged when the mobile
phone is purchased but can support power on. Please recharge it for use after complete use
up the battery for the first three times, which makes this battery easier to achieve the best
using state.
1.1.1 Installation of battery
Put the back of the mobile phone upward; press the clip first then take off the rear
cover according to the picture below.
Dig out the bottom of the battery and get the battery out.
When installing the battery, insert the metal teeth at the top of the battery into corresponding
slot of the mobile phone, and then press the battery down to install the battery in place. The
battery must be installed before power on.
1.1.2 Charging the battery
Put the charging connector to the phone like the picture below:
Connect to the charging plug to the socket of the Power Supply
After charging, take out of the charging connector.
Battery Use：When the power of the battery is lower than normal, the phone will prompt
battery low. Please charge the battery, otherwise you will lose any files which are not
saved. If you don’t charge for a long time, the phone will be powered off automatically.
When charging, the battery icon in the right upper corner of the screen will appear in a
dynamic rolling manner. During the charging period, the battery, mobile phone and charger will
become hot, which is normal.
To Next Page
Loading...
Need help?
General
