A. Locate DLC on vehicle.
• A plastic DLC cover may be found for some vehicles and you
need to remove it before plugging the OBD2 cable.
B. Plug the tool's OBD II cable to the vehicle's DLC.
• System Setup
The scan tool allows you to make the following adjustments and
settings:
1. Language: Selects the desired language.
2. Configure Monitors: Sets the monitors you want to test.
3. Unit of measure: Sets the unit of measure to English or Metric.
4. Key Beep Set: Turns on/off key-press beep.
5. Status Beep Set: Turns on/off the I/M Readiness Status beep.
6. Tool Self-test: Checks if the LCD display, LED lamps and keyboard
are working normally.
7. Update Mode: Accesses the Update Mode.
8. Settings of the unit will remain until change to the existing settings
made.
To enter the Setup menu
To Next Page
Loading...
Need help?
General