This function allows you to turn on/off the build-in speaker for key
pressing.
◆ The default setting is Beep On.
1. From System Setup screen, use the Direction button to sele Key
Beep Set and press the OK button.
2. From Key Beep Set menu, use the Direction button to select Beep
ON or Beep OFF to turn on/off the beep.
3. Press the OK button to save your selection and return to previous
menu.
• Status Beep Set
• The default setting is Beep
This function allows you to turn on/off the build-in speaker for the
LEDs in diagnostic testing. Different audio tone corresponds to
different LED lamp. This function is invaluable when working in bright
areas where LED illumination alone is not sufficient.
◆ From System Setup screen, use the Direction button to sele
Status Beep Set and press the OK button.
◆ From Status Beep Set menu, use the Direction button to select
Beep ON or Beep OFF to turn on/off the beep.
• Tool Self-test
The Tool Self-test function checks if the display, LED lam and
keyboard are working properly.
• Display test
To Next Page
Loading...
Need help?
General