EasyManua.ls Logo

JDS Uniphase HST-3000 - Specifications; Data Capability

JDS Uniphase HST-3000
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ISDN Testing
U Interface
BERT Single channel independent of call set-up
BER testing patterns All ones,all zeros, 511,
2047,2E15-1,2E20-1,2E23-1, programmable user pattern
Supporting PVC service testing
IDSL BER testing at 128 kbps and 144 kbps
Timed tests
Facilities Testing
User-configured loopbacks
Margin testing (dB Loss Pad selection) U interface
Call appearance
Auto SPID testing
Physical Specifications
Size (h x w x d) 9.5 x 4.5 x 2.75 in.(241 x 114 x
70 mm)
Weight (with battery) 2.7 lbs.(1.23 kg)
Operating temperature 22° F to 122° F (5.5° C to 50° C)
Storage temperature -40° F to 150° F
(-40° C to 65.5°C)
Battery life 10 hrs.typical usage
Charging time 7 hrs.from full discharge
to full charge
Operating humidity 10% to 80% relative humidity
Storage humidity 10% to 95% relative humidity
Display 3.8”diagonal,1/4 VGA,Color Active Matrix
with backlight (readable in direct sunlight)
General Specifications
Ruggedness Survives 3 feet (91 cm) drop
to concrete on all sides
Water-resistant Splashproof (may be used in
heavy rain)
Languages English,German, French,Spanish,
Italian,Chinese,Turkish
Keypad Typical 12-button keyboard
Technical Specifications
Interfaces
U-interface 2-wire 8-pin modular
10/100 BT Ethernet jack 8-pin modular
Serial port DB9 female via cable (DCE)
USB Host
USB Device
ISDN BRI Specifications
Interface U Interface with To LT and To NT
Devices NT1
Physical Configuration
Point to Point, Synchronous and Full-Duplex
Bit Rate 160 kbps ±5ppm
User Data Rate 144 kbps ±5ppm
Line Coding 2B1Q
Maximum Voltage ±2.5 V ±5%
Bits Per Frame 240
Bits User Data 216
Bits Overhead 24
Frames Per Second 666.66666…
Modes of Operation NT1/TE LT Emulate
U-Monitor (option)
Call Controls
5ESS per AT&T 5D5-900-321
NTI-F per NT NIS-S208
NATIONAL per Bellcore Documents
for NI-1, NI-2,and NI-3
Layer Analysis
Layer 1 states
Layer 2 (LAPD) states
Layer 3 (call status) states
Cause messages
Loopbacks
D-channel decode monitor (DB-9)
D-channel message capture/LCD display/state
Voice Capability
Hands-free operation and Headset interface
DTMF dialing
B-channel selection
Dual call capability
Selectable call appearance
Calling party ID
Speed dialing (10, 30-digit numbers)
Data Capability
Circuit switched data calls
Selectable for 56 kbps or 64 kbps
5
H
ST-3000 ISDN BRI SIM
Specifications

Other manuals for JDS Uniphase HST-3000

Related product manuals