Need help?Do you have a question about the JDS Uniphase SmartClass E1 and is the answer not in the manual?
General| Model | SmartClass E1 |
|---|---|
| Category | Test Equipment |
| E1 Interfaces | 1 |
| Display | LCD |
| Supported Standards | G.703, G.704 |
| Bit Rate | 2.048 Mbps |
| Impedance | 75 ohms (coaxial), 120 ohms (balanced) |
| Interface | BNC (coaxial), RJ-45 (balanced) |
| Line Coding | HDB3 |
| Framing | PCM30, PCM31 |
| Pulse Shape Mask | Compliant with G.703 |
| Test Modes | BERT |
| BERT Patterns | 2^15-1, 2^20-1, QRSS |
| Frame Analysis | Frame Relay |
| Alarm Generation | AIS, LOS, LOF |
| Error Measurement | Bit Errors |
| Alarms | AIS, LOS, LOF, RAI, MFRA |
| Dimensions | 220 mm x 110 mm x 50 mm |
Provides initial steps to set up and prepare the tester for operation.
Instructions on how to charge the tester's batteries.
Identifies and describes the controls and LEDs on the front panel.
Details the connectors located on the left and right side panels.
Step-by-step guide to turn the SmartClass E1 Tester ON.
Instructions for powering down or putting the tester into sleep mode.
Explains how to navigate through the tester's menus and screens.
Details how to use the keypad for input and navigation.
How to save, restore, or view test configurations.
Procedure for initiating or resuming a test on the unit.
How to terminate an ongoing test at any time.
Instructions for configuring and running tests for a specific duration.
Step-by-step guide to start an E1 test application on the tester.
How to perform bit error rate testing on E1 circuits in Terminate mode.
Instructions for looping the entire E1 circuit for testing.
Steps to start the datacom testing application on the tester.
Procedure for performing bit error rate tests on data communication interfaces.
Step-by-step guide to run a VT100 session on the E1/Datacom Tester.
Procedure for charging the batteries using the AC adapter.
Step-by-step instructions for replacing the unit's batteries.
Common problems and their solutions for the E1 Tester.
To Next Page
