Chapter 3 Basic Testing
Managing test configurations
24 SmartClass E1 Tester User’s Guide
Managing test configurations
After specifying test settings, you can save the configuration, and then restore
it at a later time when you want to run a test using the same settings. You can
also view a stored test configuration to verify it matches the desired settings
before using it. If you no longer need the configuration, you can delete it.
Saving a configuration
To save a test configuration
1 If you haven’t already done so, launch your test application (see
“Launching an E1 test application” on page 28), and configure the test
(see “Specifying test application settings” on page 29).
2 On the Configuration menu, select Save/Restore-View.
A menu appears.
3 Select Save Config.
A screen appears prompting you for a filename for the configuration file.
4 Enter a filename, and then press OK.
The configuration file is saved.
Restoring a configuration
To restore a saved test configuration
1 On the Configuration menu, select Save/Restore-View.
A menu appears.
2 Select Restore/View.
A menu appears listing all saved configurations.
3 Use the up and down arrows to highlight the configuration you want to
restore, and then the right arrow.
The configuration is restored.
Viewing a configuration
To view a saved test configuration
1 On the Configuration menu, select Save/Restore-View.
A menu appears.
2 Select Restore/View.
A menu appears listing all saved configurations.
3 Use the up and down arrows to highlight the configuration you want to
restore, and then press OK.
The configuration is displayed on the screen.
To Next Page
Loading...
