JDS Uniphase SmartClass E1 - Ping Results

Chapter 7 Test Results
Frame relay results
SmartClass E1 Tester User’s Guide 99
Ping results Table 32 lists results in the Ping category. These results only appear if you
configure the E1 Tester to transmit a Ping load.
Test Frm Lost Count of frame relay frames lost by the network based
on gaps in sequence numbers.
% Lost Frm Percentage of total TTC test frames lost by the network
based on gaps in sequence numbers.
Table 31 Link results (Continued)
Result Definition
Table 32 Ping results
Result Definition
Tx Pings Count of transmitted ping packets since the last test
restart.
Echoed Pings Count of echo frames transmitted since the start of the
test.
Lost Pings Count of Echo messages that were not replied to. This
result also includes out of order Echo Reply messages
and corrupted order Echo Reply messages.
Min Delay (ms) Minimum round trip delay, measured in milliseconds,
since the start of the test.
Avg Delay (ms) Average round trip delay, measured in milliseconds,
since the start of the test.
Max Delay (ms) Maximum round trip delay, measured in milliseconds,
since the start of the test.
Ping State Displays the ping status:
–Idle
– Inverse ARP Active
–OK
– Host Unreachable
– Network Unreachable
– Protocol Unreachable
– Port Unreachable
– Fragmentation Needed but DF Bit Set
– Unknown Network
– Unknown Host
– TTL Failed During Transit
– TTL Failed During Reassembly
– Network Prohibited
– Host Prohibited
–Network TOS
–Host TOS
– Unknown Error