Chapter 2 Instrument Settings
Setting the date and time
SmartClass E1 Tester User’s Guide 19
Setting the date and time
The E1 Tester has an internal clock that you can set to provide accurate time
stamps for test results. By default, the clock uses a 12-hour format and
presents dates in a MM/DD/YYYY format. You can optionally configure your
unit to use a 24-hour time format or a DD/MM/YYYY date format. For example,
you can configure the E1 Tester to display midnight, January 15th in the
following manner:
Changing the date or time
format
The following procedure describes how to change the date or time format on
your unit.
To change the date or time format
1 Select System Settings from the Main Menu.
2 Select Set Time/Date Format.
3 Do one of the following:
– To change the format used to display the time, select Time Format,
and then select the new format.
– To change the format used to display the date, select Date Format,
and then select the new format.
The format is changed.
Setting the date or time
The following procedure describes how to set the date or time.
To set the date or time
1 Select System Settings from the Main Menu.
2 Select Set Time/Date.
3 Do one of the following:
– To set the time, select Set Time, and then enter the time.
– To set the date, select Set Date, and then enter the date.
The date or time is set.
Time format Time displayed Date format Date displayed
12-hour 12:00:00 AM
MM/DD/YYYY 01/15/2007
24-hour 00:00:00 DD/MM/YYYY 15/01/2007
To Next Page
Loading...
