Chapter 3 Basic Testing
Viewing test results
26 SmartClass E1 Tester User’s Guide
Viewing test results
After the E1 tester is connected to the circuit and test is started, the unit imme-
diately accumulates and displays results in the Summary and Signal result
categories. After you start a test and transmit traffic, additional test results
populate the remaining categories.
To view test results
1 If you haven’t already done so, launch a test application (see “Launching
an E1 test application” on page 28 or “Launching the datacom application”
on page 52).
2 Start the test.
3 On the Main menu for the test, select Results.
A menu of result categories applicable to you test appears.
4 Select a result category.
5 If necessary, use the up / down arrow keys or the OK key to select Rx1 or
Rx2 results.
Test results appear for the category you selected. After the test is complete
and all results have accumulated, the status bar at the bottom of the results
display blinks and indicates that the results are complete.
You can clear existing result values and then accumulate new values using the
Restart action.
The test results for the category appear. For descriptions of test results, see
Chapter 7 “Test Results”.
Remote Control
With the remote control option, you can connect to a E1 Tester in order to
control it remotely using command lines via the serial interface. A command
guide is available with the option.
To Next Page
Loading...
