Chapter 5 Datacom Testing
Frame Relay testing
72 SmartClass E1 Tester User’s Guide
8 Connect the E1/Datacom Tester to the circuit. For more information, see
“Connecting the E1/Datacom Tester to the circuit” on page 61.
9 On the Test menu, select Restart to begin the test.
You are monitoring frame relay traffic on a datacom interface.
Transmitting traffic over a
Datacom interface
The E1/Datacom Tester can also transmit frame relay traffic over a Datacom
interface.
To transmit frame relay traffic over a Datacom interface
1 f you haven’t already done so, launch the Frame Relay application (see
“Launching the Frame Relay application” on page 64).
2 On the Configuration menu, select Data Comm., and then specify the
settings.
3 Specify the frame load settings. See “Configuring the frame load settings”
on page 66.
4 Specify the frame header settings. See “Configuring the frame header
settings” on page 68.
5 Specify the local management interface settings. See “Configuring the LMI
Settings” on page 69.
6 Specify how link trace results should be displayed. See “Configuring the
trace settings” on page 70.
7 Configure flow control settings. See “Specifying flow control settings” on
page 70.
8 After you finish configuring the test settings, press Cancel to return to the
Test menu.
9 Connect the E1/Datacom Tester to the circuit. For more information, see
“Connecting the E1/Datacom Tester to the circuit” on page 61.
10 On the Test menu, select Restart soft key to begin the test.
The E1/Datacom Tester transmits frame relay traffic over the Datacom inter-
face.
To Next Page
Loading...
