Chapter 1 Getting Started
Options
SmartClass E1 Tester User’s Guide 3
– Physical layer defects (alarms), anomalies (errors), and statistics are
collected during the test.
– Auto configure to automatically select the interface, framing, and
pattern.
– Line rate throughput testing
– Line loopback testing
– Round trip delay measurement
– Terminate, Monitor, Bridge, and Loopback testing
– Pulse shape (option)
– MFC-R2 Signaling (option)
– Datacom Testing features
– DTE emulate, DCE emulate and monitor mode
– X.21, V.24 (RS-232), V.35, V.36 (RS-449), EIA-530
–V. delay
–Frame Relay
– G.703 Co-directional, Contra-directional and Centralized interface
testing
Options
The SmartClass E1 Tester has factory-configurable options as well as options
available for field upgrade. You can expand your testing capability by
purchasing optional software or accessories.
Configurations
The SmartClass E1 Tester is factory configurable with or without Datacomm.
Table 3 describes the available configurations.
Table 3 SmartClass E1 Tester configurations
Catalog Number Option
CSC-E1-P1 SmartClass
E1 Tester. Allows you to test E1 services.
CSC-E1-P2 SmartClass E1 Tester with the PS option. Allows you to
test E1 services, including Pulse Shape.
CSC-E1-P3 SmartClass
E1 Tester with the JIT option. Allows you to
test E1 services, including Jitter.
CSC-E1-P4 SmartClass
E1 Tester complete package. Allows you to
test E1 services, including Pulse Shape and Jitter.
CSC-E1DC-P1 SmartClass E1 Datacomm Tester. Allows you to test E1
and Data communication services.
CSC-E1DC-P2 SmartClass E1 Datacomm Tester with PS and FR
options
. Allows you to test E1 services, including Pulse
Shape, and Data communication services, including Frame
Relay.
CSC-E1DC-P3 SmartClass
E1 Datacomm Tester with PS, SIG, and
VT100 options
. Allows you to test E1 services including
Pulse Shape, MFC-R2 signaling, and VT100, as well as
Data communication services, including Frame Relay.
To Next Page
Loading...
