JDS Uniphase SmartClass E1 - E1 Testing

4
SmartClass E1 Tester User’s Guide 27
Chapter 4 E1 Testing
This chapter provides task-based instructions for turning up and trouble-
shooting E1 service using the SmartClass E1 Tester. Topics discussed in this
chapter include the following:
– “About E1 testing” on page 28
– “Launching an E1 test application” on page 28
– “Specifying test application settings” on page 29
– “Monitoring a circuit” on page 38
– “Measuring timing slips” on page 39
– “Terminate testing” on page 40
– “Line loopback testing” on page 41
– “Pulse shape analysis” on page 42
– “Measuring Jitter” on page 43
– “Testing MFC-R2 Signaling” on page 46