Page 19 of 28
Technical Support tac@jdsu.com 1 866 228-3762
Systems Engineer Dave.Baker@jdsu.com 321-243-0600
7. Configure Test Press the Configure Navigation key to configure test setting. Using the
Right Arrow key or Settings soft key, scroll through Settings menus
and configure your test as follows. Leave all other values at default,
unless specified in the Work Order.
For Layer 2 Testing:
For Layer 3 IP Testing:
8. View Results Press the Home key to display Summary Results.
9. Turn Laser On For optical testing, press the Action soft key and select Laser On.
10. Restart Press the Restart soft key to reset test results.
11. Check LED Results Press the Right Arrow key until LED Results are displayed. A Green
Signal Present LED indicates that the HST-3000 is receiving an optical
signal from the near end Ethernet Switch. Green Sync Acquired and
Link Active LEDs indicate that the HST-3000 has successfully
connected to the near end Ethernet switch and the Ethernet link is active.
Set to same values as
Ethernet switch port.
Set to same values as
Ethernet switch port.
To Next Page
Loading...
