JDS Uniphase T-BERD 6000A - Page 28

Page 28 of 28
Technical Support tac@jdsu.com 1 866 228-3762
Systems Engineer Dave.Baker@jdsu.com 321-243-0600
2. Reset to Defaults In the Tools menu, select Reset Test to Defaults. Press OK to continue.
3. Setup Press the SETUP soft key on the top right side of screen.
For Electrical Handoffs: Select the indicated folders and configure your
test as follows.
Folder
Option
Value(s)
Comment
Interface,
Connector
Electrical
Connector
SFP1 or SFP2
Select
ETHERNET 1000BASE-T SFP
Interface,
Physical
Layer
Auto
Negotiation
See Work Order
Set to same value as Ethernet switch port.
For Optical Handoffs: Select the indicated folders and configure your
test as follows.
Folder
Option
Value(s)
Comment
Interface,
Connector
Optical
Connector
SFP1 or SFP2
Select desired optical SFP (1000BASE-
SX, 1000BASE-LX, etc.)
Interface,
Physical
Layer
Auto
Negotiation
See Work Order
Set to same value as Ethernet switch port.
For all handoffs: Select the indicated folders and configure your test as
follows. Leave all other values at default, unless specified in the Work
Order.
Folder
Option
Value(s)
Comment
All Streams
Source IP
Type
Static
Source IP
See Work Order
For Layer 2 handoffs, set to 192.168.1.3
Default
Gateway
See Work Order
For Layer 2 handoffs, set to 192,168.1.1
Subnet Mask
See Work Order
For Layer 2 handoffs, set to
255.255.255.0
1, Ethernet
Encapsulation
See Work Order
None or VLAN
VLAN ID
See Work Order
Options displayed after tapping VLAN
field if Encapsulation = VLAN
1, IP
Destination IP
See Work Order
Options displayed after tapping
Destination IP Address field. For Layer
2 handoffs, set to 192,168.1.2
TCP Host,
Ethernet
Encapsulation
See Work Order
None or VLAN
VLAN ID
See Work Order
Options displayed after tapping VLAN
field if Encapsulation = VLAN
TCP Host,
TCP Host
Settings
TCP Host
Mode
Client
4. View Results Press the RESULTS button, to display the Results screen.
5. Test Inform the A-side technician that you are ready for test.