Jeep 2006 commander User Manual

FOUR-WHEEL DRIVE OPERATION
Quadra-Trac I姞 Operating
Instructions/Precautions — If Equipped
The Quadra-Trac I威 is a single speed (HI range only)
transfer case which provides convenient full-time
4–wheel drive. No driver interaction is required. This
transfer case divides engine torque almost evenly with 48
percent of engine torque to the front axle and 52 percent
of engine torque to the rear axle. The Brake Traction
Control System (BTC), which combines standard ABS
and Traction Control, provides resistance to any wheel
that is slipping to allow additional torque transfer to
wheels with traction.
NOTE: The Quadra-Trac I威 system is not appropriate
for conditions where LOW range is recommended. Refer
to “Off-Road Driving Tips” in this section.
Quadra-Trac II姞 Operating
Instructions/Precautions — If Equipped
The Quadra-Trac II威 transfer case is fully automatic in the
normal driving 4 HI mode. The Quadra-Trac II威 transfer
case provides three mode positions — four wheel drive
high range, neutral, and four wheel drive low range.
This transfer case is fully automatic in the 4 HI mode.
This transfer case divides engine torque almost evenly
with 48 percent of engine torque to the front axle and 52
percent of engine torque to the rear axle. When speed
differences are increased between the front and rear drive
shafts, the transfer case can transmit up to 100 percent of
available engine torque to the front or rear drive shafts.
When additional traction is required, the 4 LOW position
can be used to lock the front and rear driveshafts together
and force the front and rear wheels to rotate at the same
speed. The 4 LOW position is intended for loose, slippery
264 STARTING AND OPERATING

Jeep 2006 commander Specifications

General

Brand	Jeep
Model	2006 commander
Category	Automobile
Language	English