CAUTION!
Make sure storage cap is installed to prevent foreign
materials from entering washer tube and clogging
system, and also to prevent fluid from being sprayed
into the rear of the vehicle.
8. Disconnect the wire harness from the hard top by
pressing the tab at the side of the connector and pulling
to disconnect.
NOTE: If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock the
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected from the hard
top.
9. Close the swing gate.
10. Remove the hard top from the vehicle. Place on a soft
surface to prevent damage.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
