6. Make sure the Sunrider bracket on the side bows
latches to the door rails (Sunrider Models Only).
7. Open the header latches and engage the hook on each
side onto the windshield loops (do not close the latches).
8. If the swing gate brackets were removed, install them
by hooking the rear edge of the bracket on the interior
side of the body channel. Then, rotate it rearward and
over the channel until it snaps onto the exterior part of
the rail. To be properly located, the bracket must only be
clipped to the shortened rail edge.
144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
