With Tip Start
If the engine fails to start after you have followed the
⬙Normal Starting⬙, “Extreme Cold Weather⬙ and ⬙Ex-
tended Park Starting⬙ procedures, it may be flooded. To
clear any excess fuel;
1. Press the accelerator pedal all the way to the floor and
hold it
2. Cycle the ignition to the START position and release it
as soon as the starter engages. The starter motor will
disengage automatically in 10 seconds.
3. Once this occurs, release the accelerator pedal.
4. Cycle the ignition to the LOCK position, wait 10 to 15
seconds, then repeat the “Normal Starting” procedure.
CAUTION!
To prevent damage to the starter, wait 10 to 15
seconds before trying again.
After Starting
The idle speed is controlled automatically and it will
decrease as the engine warms up.
STOP/START SYSTEM — IF EQUIPPED
The Stop/Start function is developed to reduce fuel
consumption. The system will stop the engine automati-
cally during a vehicle stop if the required conditions are
met. Releasing the brake pedal or pressing the accelerator
pedal will automatically re-start the engine.
Automatic Mode
The Stop/Start feature is enabled after every normal
customer engine start. At that time, the system will go
5
STARTING AND OPERATING 477
To Next Page
Loading...
