Jeep CHEROKEE 2021 - Garage Door Opener

HomeLink
®
GARAGE DOOR OPENER
While the car is ON, hold the hand-held garage door transmitter 1-3 inches
from the HomeLink
®
button you want to program in the vehicle.
1
Push and hold both the HomeLink
®
button being programmed and the button
on the garage door transmitter.
2
Push and hold the two outside HomeLink
®
buttons for 20 seconds until the orange
indicator ashes. An individual channel cannot be erased.
TO ERASEERASE ALL SET CHANNELS:
For Non-Rolling CodeFor Non-Rolling Code garage door openers, watch for the indicator light to
go constant.
For Rolling CodeFor Rolling Code garage door openers, watch for the indicator light to go from
a slow blink to blinking rapidly.
3
For Rolling CodeFor Rolling Code garage door openers only, rmly push and release the
“LEARN” or “TRAIN” button on your garage door opener motor in your garage,
then push the HomeLink
®
button in your vehicle for two long presses.
4
If the programming was successful, your garage door should open and close
with your chosen HomeLink
®
button.
5
Check your garage door opener motor in your garage for a “LEARN”
or “TRAIN” button by the hanging antenna. If you have one of these,
you have a Rolling Code garage door opener.
ROLLING OR NON-ROLLING?
?
For more detailed instructions, see “Universal Garage Door Opener
(HomeLink
®
)” in your Owner’s Manual. Please call 1-800-355-3515 if
you require assistance.
LINK YOUR GARAGE DOOR