10. To disengage the mini-latch from the mini-buckle
for storage, insert the regular latch plate into the
black button on the top of the mini-buckle. The belt
will automatically retract to its stowed position. If
necessary, slide the latch plate down the webbing to
allow the belt to retract fully. Insert the mini-latch
plate into the slot provided in the trim panel.
Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/
shoulder belt.
1. Position the latch plate as close as possible to the
anchor point.
2. At about 6 to 12 in (15 to 30 cm) above the latch plate,
grasp and twist the belt webbing 180 degrees to create
a fold that begins immediately above the latch plate.
3. Slide the latch plate upward over the folded webbing.
The folded webbing must enter the slot at the top of
the latch plate.
4. Continue to slide the latch plate up until it clears the
folded webbing.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 53
To Next Page
Loading...
