EasyManua.ls Logo

Jeep compass 2017 - Oil Change Indicator System; Instrument Cluster Display Functions

Jeep compass 2017
429 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Start Aborted Fuel Low
Remote Start Aborted System Fault
Key In Ignition
Low Tire
Low Tire Pressure Display for Premium TPM System
Service TPM System
Oil Change Indicator System
Your vehicle is equipped with an engine oil change indi-
cator system. The “Oil Change Required” message will
display in the instrument cluster display for approximately
five seconds after a single chime has sounded to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty-cycle based, which means
the engine oil change interval may fluctuate dependent
upon your personal driving style.
Unless reset, this message will continue to display each
time you place the ignition in the ON/RUN position. To
turn off the message temporarily, push and release the Trip
Odometer button on the instrument cluster. To reset the oil
change indicator system (after performing the scheduled
maintenance), refer to the following procedure.
1. Place the ignition in the ON position. Do not start the
engine.
2. Fully push the accelerator pedal, slowly, three times
within 10 seconds.
3. Place the ignition in the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
Instrument Cluster Display Functions
Compass/Temperature/Audio
Average Fuel Economy
Distance To Empty (DTE)
Units In
Elapsed Time
Tire Pressure Monitor (TPM)
Personal Settings
4
GETTING TO KNOW YOUR INSTRUMENT PANEL 103

Table of Contents

Other manuals for Jeep compass 2017

Related product manuals