38 GETTING TO KNOW YOUR VEHICLE
ILLUMINATED VANITY MIRRORS
To access an illuminated vanity mirror, flip down
one of the visors and lift the mirror cover.
Illuminated Vanity Mirror Cover
Sun Visor “Slide-On-Rod” Feature — If
Equipped
The sun visor “Slide-On-Rod” feature allows for
additional flexibility in positioning the sun visor
to block out the sun.
1. Fold down the sun visor.
2. Unclip the visor from the center clip.
3. Pivot the sun visor toward the side window.
4. Extend the sun visor for additional sun
blockage.
NOTE:
The sun visor can also be extended while the
sun visor is against the windshield for additional
sun blockage through the front of the vehicle.
OUTSIDE MIRRORS
The outside mirror(s) can be adjusted to the
center of the adjacent lane of traffic to achieve
the optimal view.
NOTE:
The passenger side convex outside mirror will
give a much wider view to the rear, and espe-
cially of the lane next to your vehicle.
POWER ADJUSTMENT MIRRORS
The power mirror switch is located on the
driver’s door panel.
To adjust an exterior power mirror, select the
right or left side using the mirror selector switch,
then push the mirror adjustment switch in the
desired direction indicated by the direction
arrows.
NOTE:
To adjust the power mirrors, the ignition must
be in the ON/RUN position.
Once the mirror is adjusted, rotate the
control to the neutral position to avoid acci-
dental movements.
CAUTION!
To avoid damage to the mirror during clean-
ing, never spray any cleaning solution directly
onto the mirror. Apply the solution onto a
clean cloth and wipe the mirror clean.
WARNING!
Vehicles and other objects seen in the pas-
senger side convex mirror will look smaller
and farther away than they really are. Relying
too much on your passenger side convex mir-
ror could cause you to collide with another
vehicle or other object. Use your inside mirror
when judging the size or distance of a vehicle
seen in the passenger side convex mirror.
21_MP_OM_EN_USC_t.book Page 38
To Next Page
Loading...
