Jeep Compass 2021 - Page 50

48 GETTING TO KNOW YOUR VEHICLE
Driver And Passenger Temperature
Control Buttons
These buttons provide the driver and passenger
with independent temperature control.
Push the red button on the faceplate
or touchscreen or press and slide the
temperature bar towards the red
arrow button on the touchscreen for
warmer temperature settings.
Push the blue button on the faceplate
or touchscreen or press and slide the
temperature bar towards the blue
arrow button on the touchscreen for
cooler temperature settings.
SYNC Button
Press the SYNC button on the
touchscreen to toggle the Sync
feature on/off. The SYNC indicator is
illuminated when SYNC is on. SYNC is
used to synchronize the passenger temperature
setting with the driver temperature setting.
Changing the passenger temperature setting
while in SYNC will automatically exit this
feature.
NOTE:
The SYNC button is only available on the touch-
screen.
Blower Control
Blower Control is used to regulate the
amount of air forced through the
Climate Control system. There are
seven blower speeds available.
Adjusting the blower will cause automatic mode
to switch to manual operation. The speeds can
be selected using either the blower control knob
on the faceplate or the buttons on the
touchscreen.
Faceplate
The blower speed increases as you turn the
blower control knob clockwise from the lowest
blower setting. The blower speed decreases as
you turn the blower control knob
counterclockwise.
Touchscreen
Use the small blower icon to reduce the blower
setting and the large blower icon to increase the
blower setting. Blower can also be selected by
pressing the blower bar area between the icons.
Mode Control
Mode Control regulates the airflow
distribution. The airflow distribution
outlets are: instrument panel outlets,
floor outlets, defrost outlets, and
demist outlets.
Faceplate
Push the Mode Button to change the airflow
distribution mode.
CAUTION!
Failure to follow these cautions can cause
damage to the heating elements:
 Use care when washing the inside of the
rear window. Do not use abrasive window
cleaners on the interior surface of the
window. Use a soft cloth and a mild
washing solution, wiping parallel to the
heating elements. Labels can be peeled off
after soaking with warm water.
 Do not use scrapers, sharp instruments, or
abrasive window cleaners on the interior
surface of the window.
 Keep all objects a safe distance from the
window.
21_MP_OM_EN_USC_t.book Page 48