104 IN CASE OF EMERGENCY
3. Grab the boot material rearward of the gear
selector and pull up to carefully separate
the gear selector bezel and boot assembly
from the center console.
Gear Selector Bezel
4. Press and maintain firm pressure on the
brake pedal.
5. Insert a small screwdriver or similar tool
down into the gear selector override access
hole (at the right rear corner of the gear
selector assembly), and push and hold the
override release lever down.
Gear Selector Override Access Hole
6. Move the gear selector to the NEUTRAL
position.
7. The vehicle may then be started in
NEUTRAL.
8. Reinstall the gear selector boot.
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand or
snow, it can often be moved using a rocking
motion. Turn the steering wheel right and left to
clear the area around the front wheels. For
vehicles with automatic transmission, push and
hold the lock button on the gear selector. Then
shift back and forth between DRIVE (D) and
REVERSE (R) (for automatic transmission) or
SECOND gear and REVERSE (for manual
transmission) while gently pressing the
accelerator.
NOTE:
For vehicles with automatic transmission, shifts
between DRIVE and REVERSE can only be
achieved at wheel speeds of 5 mph (8 km/h) or
less. Whenever the transmission remains in
NEUTRAL (N) for more than two seconds, you
must press the brake pedal to engage DRIVE or
REVERSE.
21_M6_EIG_EN_IN_t.book Page 104
To Next Page
Loading...
Need help?
General
