88 IN CASE OF EMERGENCY
5. Raise the vehicle just enough to remove the
flat tire.
6. Remove the wheel bolts and tire.
7. Remove the alignment pin from the jack
assembly and thread the pin into the wheel
hub to assist in mounting the spare tire.
8. Mount the spare tire.
Mounting Spare Tire
NOTE:
For vehicles equipped, do not attempt to install
a center cap or wheel cover on the compact
spare.
9. Install and lightly tighten the wheel bolts.
10. Lower the vehicle to the ground by turning
the jack handle counterclockwise.
11. Finish tightening the wheel bolts. Push
down on the wrench while at the end of the
handle for increased leverage. Tighten the
wheel bolts in a star pattern until each
wheel bolt has been tightened twice
Ú page 171. If in doubt about the correct
tightness, have them checked with a torque
wrench by an authorized dealer or at a
service station.
WARNING!
Raising the vehicle higher than necessary can
make the vehicle less stable. It could slip off
the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
CAUTION!
Be sure to mount the spare tire with the valve
stem facing outward. The vehicle could be
damaged if the spare tire is mounted
incorrectly.
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the wheel nuts fully until
the vehicle has been lowered. Failure to
follow this warning may result in serious
injury.
21_M6_EIG_EN_IN_t.book Page 88
To Next Page
Loading...
