Jeep Compass
Towing/lifting the vehicle
Fitting the towing attachment
Front towing attachment
The front towing attachment is located behind a flap behind a flap
on the front bumper.
To fit the attachment, open the flap using the car key or a small
screwdriver, then tighten the attachment in its housing.
Insert the flat end of the jack lever through the towing attachment,
then tighten it; for more information, see "Lifting the car and
changing a wheel" in this section. The towing attachment must be
completely inserted in the respective fastening bracket through the
lower part of the front bumper. Do not tow the car if the towing
attachment is not completely inserted in the fixing
bracket.
Position of the front towing attachment
To Next Page
Loading...
Need help?
General
