174 STARTING AND OPERATING
The vehicle parking brake is applied
The braking temperature exceeds normal
range (overheated)
The Trailer Sway Control (TSC) activates
The vehicle speed is less than 15 mph
(24 km/h) (manual transmission only)
The clutch is pressed for more than 10
seconds (manual transmission only)
The vehicle is placed in NEUTRAL for more
than 10 seconds (manual transmission only)
The driver shifts to FIRST gear (manual trans-
mission only)
The following conditions will only cancel the ACC
system:
Driver seat belt is unbuckled at low speeds
Driver door is opened at low speeds
To Turn Off
The system will turn off and erase the set speed
in memory if:
The Adaptive Cruise Control (ACC) on/off
button is pushed
The Fixed Speed Cruise Control on/off button
is pushed
The ignition is placed in the OFF position
4WD Low is engaged
To Resume
If there is a set speed in the memory, push the
RES button and then remove your foot from the
accelerator pedal. The instrument cluster
display will show the last set speed.
Resume can be used at any speed above
20 mph (32 km/h) when only Fixed Speed
Cruise Control is being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
After setting a speed, you can increase the set
speed by pushing the SET (+) button, or
decrease speed by pushing the SET (-) button.
U.S. Speed (mph)
Pushing the SET (+), or SET (-) button once
will result in a 1 mph speed adjustment. Each
subsequent tap of the button results in an
adjustment of 1 mph.
If the button is continually pushed, the set
speed will continue to adjust in 5 mph incre-
ments until the button is released. The new
set speed is reflected in the instrument
cluster display.
Metric Speed (km/h)
Pushing the SET (+), or SET (-) button once
will result in a 1 km/h speed adjustment.
Each subsequent tap of the button results in
an adjustment of 1 km/h.
If the button is continually pushed, the set
speed will continue to adjust in 10 km/h
increments until the button is released. The
new set speed is reflected in the instrument
cluster display.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for pre-
vailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to fol-
low these warnings can result in a collision
and death or serious personal injury.
21_JL_OM_EN_USC_t.book Page 174
To Next Page
Loading...
