58 GETTING TO KNOW YOUR VEHICLE
(Continued)
outside conditions such as smoke, odors, dust,
or high humidity are present. Recirculation can
be used in all modes except for Defrost.
Recirculation may be unavailable if conditions
exist that could create fogging on the inside of
the windshield. The A/C can be deselected
manually without disturbing the mode control
selection. Continuous use of the Recirculation
mode may make the inside air stuffy and
window fogging may occur. Extended use of this
mode is not recommended.
On systems with Manual Climate Controls (if
equipped), the Recirculation mode is not
allowed in Defrost mode to improve window
clearing operation. Recirculation is disabled
automatically if this mode is selected.
Attempting to use Recirculation while in this
mode causes the LED in the control button to
blink and then turns off.
Front Defrost Setting
Turn the Mode Control knob to the
Front Defrost mode setting. Air comes
from the windshield and side window
demist outlets. When the Defrost
button is selected, the blower level may
increase. Use Defrost mode with maximum
temperature settings for best windshield and
side window defrosting and defogging.
Rear Defrost Button
Push and release the Rear Defrost
Control button to turn on the rear
window defroster and the heated
outside mirrors (if equipped). The
Rear Defrost indicator illuminates when the rear
window defroster is on. The rear window
defroster automatically turns off after
10 minutes.
Temperature Control
Temperature Control regulates the temperature
of the air forced through the climate system.
The temperature increases as you
turn the temperature control knob
clockwise.
The temperature decreases as you
turn the temperature control knob
counterclockwise.
Heater Only
Turning the temperature control knob clockwise
increases the heating temperature and turning
the temperature control knob counterclockwise
decreases the heating temperature.
NOTE:
The numbers within the temperature display will
only appear if your vehicle is equipped with an
Automatic Climate Control system.
CAUTION!
Failure to follow these cautions can cause
damage to the heating elements:
Use care when washing the inside of the
rear window. Do not use abrasive window
cleaners on the interior surface of the
window. Use a soft cloth and a mild
washing solution, wiping parallel to the
heating elements. Labels can be peeled off
after soaking with warm water.
Do not use scrapers, sharp instruments, or
abrasive window cleaners on the interior
surface of the window.
Keep all objects a safe distance from the
window.
CAUTION! (Continued)
21_JL_OM_EN_USC_t.book Page 58
To Next Page
Loading...
