To Next Page

To Previous Page

Amplifier Front Panel Functions and IndicatorsAmplifier Front Panel Functions and Indicators

Before attempting any system interconnection, please familiarize yourself with the front panel control

of the Model 302 Stereo Power Amplifier. The descriptions below refer to the illustration on the adjacent

page.

FRONT PANEL STANDBY/POWER BUTTON: Press this button to operate the amplifier. Press again to

place the amplifier in Standby mode.

FRONT PANEL STANDBY/POWER INDICATOR: This small, blue light will illuminate when the amplifier is

operational. When the light is not illuminated, all amplifier inputs are muted and internal circuitry

reverts to power-saving (Standby) mode.

To avoid spurious noises and possible damage to the amplifier's internal circuitry, the amplifier should

be switched to Standby mode when connecting or disconnecting any rear panel connections.

Note: All ON/OFF power switching should be initiated ONLY with this button. The amplifier should not

be disconnected from AC power without first placing the amplifier in Standby mode. Avoid the use of

switched AC power outlets to control or switch AC power to the amplifier.